Details about the SIENNA technology including address assignment and technical data can be found here:

SIENNA CONCEPT
SAMDR

SAMDR

SAMDR-ST01-H01

EAN 4260194734037

Sensor / Dim-actuator combination,
Leading-edge

The SIENNA SAMDR sensor / actuator has an 230V input and a Triac switched output (leading-edge) for ohmic loads up to 300W. Loads up to 150W are allowed when the actuator is used with universal electronic transformers. In overload conditions, the actuator switches off automatically and can be activated only after a predefined cooling phase of 60s. Compatible with LEDs that are designed to work with leading-edge dimmers.

One binary input (L, 1) with 230V / ~50Hz. Can also be used with switches that have an integrated control light.
L’ for connecting to load; One leading-edge output rated at 300W (Cos φ = 1) for dimming L’.
 R, L loads up to 300W (cos φ = 1) ; 150W (cos φ = 0,6).

 LEDs, that are designed to work with leading-edge dimmers.

 Universal electronic transfromers for loads up to 150W; Takes into account the min. load requirements for universal transformers; Dims in the range from 30% – 100%. Can also be used to control appropriate motors (e.g. pumps for fountains).

SAMDU

SAMDU

SAMDU-ST04-H01

EAN 4260194734068

Sensor / Dim-actuator combination,
Universal

The SIENNA SAMDU sensor / actuator has an 230V input and an universal dimming output (leading-edge or trailing-edge) for loads up to 300W. Retrofit LEDs (230V) are limited to loads up to 100W.
Please note: This dimmer casing has a height of 38.5mm which is different as compared to the other flush mounted units!

One binary input (L, 1) with 230V / ~50Hz. Can also be used with switches that have an integrated control light.
for connecting to load; One universal dimmed output (leading-edge/ trailing-edge) for loads up to 300W.
 R, L, C-loads up to 300W, min. brightness 10%.

 Retrofit LED bulbs, max. 150W.

 R, L, C-loads up to 300W, min. brightness 20%.

AMD10V

AMD10V

AMD10V-ST01-H01

EAN 4260194730091

Dim-actuator (1-10V)

The SIENNA AMD10V actuator can be used with electronic ballasts or other devices with a 1-10V interface (e.g. LED lamps) to switch and / or dim these devices. This actuator has a current sink of max. 30 mA and can switch up to 6 electronic ballasts connected in parallel.

Relay output L’ for switching loads up to 10A. N is bridged to the neutral of the power supply. Output +, – is a 1-10V output for dimming the load. Output can have max. 30mA when operated with several loads connected in parallel.

The 1-10V is available via the active output. Hence the output is compatible with both active and passive 1-10V interfaces.

All dimmers can be combined with the sensors:
SM1L, SM2, SM4 / SM8 und SM3